It was last year when I posted about RRS having secured the rights to distribute the Dynacorn Fastback body shells here in Australia. Well a few months have passed and they are now available to the public. RRS have teamed up with The Blue Oval Garage out of Victoria, Australia to distribute the right hand drive shells which are promoted as ‘The world’s first factory built RHD 1967 Mustang”. The shells are very enticing having been rust-proofed and edp coated for added protection and not to mention the body and panel alignment built to a higher standard than original Ford production vehicle of the 60’s Which one would think would make fitting your Eleanor body kit easier (if that’s what you intend to build). You can buy the RHD shell for $AUD 32,600, the same price that was originally quoted late last year and for an extra $AUD 9,900 you can have it come with the various body panels such as; Front Stone Guard, Front Valance, Valance to Render Braces pr., Front Fender – RH, Front Fender – LH, Outer Shock Tower RH, Outer Shock Tower LH, Grill & Grill Mouldings, Fibreglass Hood with Steel Black, Headlight buckets and the list goes on. What I didn’t post about last yeah though was the RRS suspension kit. So here it is in full. Prices are in $AUD Suspension kit – incl GST Coil Over Suspension Assy. $3,360 Ph 1 brake package 287mm rotor $685 Ph 2 brake package 297mm rotor $975 Ph 3 brake package 330mm rotor $1,550 Ph 3 with 6 pist. cal. brake package 330mm rotor $2,550 Ph 4 with 6 pist. cal. brake package 345two piece rotor $3,995 Tie Rod adj. sleeves $135 Reinforced Lower Control arms $340 Billet Caps $365 Under-dash booster & master cyl. from: $2,190 Strut Rod adj. kit from… $75 Notching Kit (optional) $290 Strut brace kit from $395 Race Bred Pump kit $700 Rack & Pinion with brackets & internal conversion shaft $2,860 Hydraulic lines high & low pressure $365 Three link rear suspension package incl. 9” diff housing $5,060 Axle small bearing 28 or 31 spline from: $870 Diff Centre/3rd member from: $2,250 Rear disc kit #1 -285mm rotor with park brake adj.from $1,320 Rear disc kit # 2 -315mm rotor with park brake adj.from $1,825 And if money is no object then you can take the whole package: RRS Right Hand body-shell 67, 68 & 69 Mustang, RRS panel build kit and RRS complete suspension package from…$AUD62,500 I must say though, they do look great, check out the photos below. If I were starting a fresh now I think I would probably go this way! It would save so much money I would think?